Electrolux 66301K-MN - Manual (Page 20)

20
What to do if
…
Problem Possible cause Remedy
The cooking zones will not
switch on or are not func-
tioning More than 10 seconds have
passed since the appliance
was switched on Switch the appliance on
again.
The child safety device is
switched on
l
Deactivate the child safety
device (See the section
“Child safety device”)
Several sensor fields were
touched at the same time Only touch one sensor field
Safety cut-out has been
triggered Remove any objects (pan,
cloths, etc.) that are lying
on the control panel.
Switch the appliance on
again
STOP+GO is activated
u
Switching off STOP+GO
Acoustic signal sounds
when appliance is switched
off The control panel is wholly
or partly covered by ob-
jects. Remove objects.
The residual heat indicator
is not displaying anything The cooking zone was only
on for a short time and is
therefore not hot If the cooking zone is sup-
posed to be hot, call the
Customer Service Depart-
ment.
The automatic warm up
function is not switching
itself on There is still residual heat
on the cooking zone
h
Let the cooking zone cool
down
The highest heat setting is
set
Ç
The highest heat setting
has the same power as the
automatic warm up func-
tion
The heat setting was set
using the sensor field 1. Switching off the cook-
ing zone
2 . Set the cooking zone us-
ing the sensor field
Acoustic signal sounds and
appliance switches itself on
and then off again; after 5
seconds another acoustic
signal sounds The On/Off sensor field has
been covered up, e.g. by a
cloth Do not place any objects
on the control panel
_ is lit
Overheating protection for
the cooking zone has been
triggered Switch off the cooking
zone. Switch the cooking
zone on again