Oki MC363dn - Manual (Page 21)

Getting started > 21
S
LEEP MODE
Your machine transitions from power saving mode to sleep mode after a set period of time.
In sleep mode the power consumption of the device in minimal. To cancel sleep mode,
press the Power Save button on the control panel.
NOTE
The machine will not enter sleep mode if an error occurs and the machine
requires attention.
By default, the time interval to enter sleep mode is set to 30 minutes.
You can enable or disable sleep mode.
> When the network connection is switched from wired to wireless, sleep
mode is disabled. To enable sleep mode for devices connected using
wireless LAN, enable sleep mode from the sleep mode setting menu.
> When a device using the wireless LAN connection goes into sleep mode, the
wireless LAN connection is broken. To reconnect to the wireless LAN, press
the power save button on the device to recover from sleep mode.
> After the device connected to the wireless LAN has recovered from sleep
mode, it automatically connects to the wireless access point using the same
settings as before it went into sleep mode. However, it may take up to
1 minute to connect.
> When the network connection is switched from wireless LAN to wired LAN,
sleep mode is enabled.
> Depending on your network environment, your device may wake from sleep
mode immediately. If this happens, it is recommended that you disable
sleep mode.