Meliconi Speedy 2 combo User Manual

Page 3

Remember to always make a note of the 4-digit codes for your appliances on the inside of the battery cover
when the code search and saving are finished. The codes will be required if the remote control needs to be
re-programmed following accidental deletion.

To find the code for your remote control:

1. Simultaneously press and hold for 5 seconds the buttons corresponding to the appliance for which you

would like to enter the code:

and

for the analogue TV,

and

for the decoder, or

and

for the digital TV, until the indicator light starts to flash indicating that the remote control is in the

programming state.

2. Upon release insert the code number you noted beforehand. Three flashes indicate that the code has been

memorized correctly. If not, try the code entry procedure again starting from point 1.

PROGRAMMED CODE NOTING

RE-PROGRAMMING YOUR REMOTE CONTROL BY ENTERING THE CODE NOTED DOWN

1. Simultaneously hold down the

and

buttons for 5 seconds (if you want to know the codes for the

analogue or digital TV), or

and

(if you want to know the code for the decoder), until the indicator

light starts to flash indicating that the remote control is in the programming state.

2. Release the buttons and press and release the

button within 8 seconds.

3. After a short pause, the indicator light produces four series of flashes with a space between them,

corresponding to the code you are looking for. Count the number of flashes; each series of flashes

corresponds to one figure in the code. 10 flashes correspond to 0. For example, the code 1306 corresponds

to:

4. Make a note of the code on the adhesive label inside the battery cover for quick and easy consultation.

Identify and take note of the code which you have discovered

following the code noting procedure

(see “PROGRAMMED CODE NOTING” section).

NOTE: The indicator light flashes more quickly during the search operation.

The indicator light stops flashing and the remote control exits the programming mode in the following
cases:
• if no buttons are pressed for 12 seconds
• if the end of the code search list has been reached. In this case, consult the website
www.meliconi.com.