Meliconi Speedy 2 combo - Manual (Page 2)

18
HOW TO PROGRAMME THE REMOTE CONTROL
- - Turn on the TV and select a programme.
- Simultaneously hold down the
and buttons for 5 seconds until the upper indicator light starts to flash
indicating that the remote control is in the programming state.
- Release the buttons and enter the code 0001 within 12 seconds. The indicator light begins flashing more
quickly, indicating that the remote control is ready for the search.
- Point the remote control towards the TV. Press and slowly release the button several times, stopping when
the appliance goes off (you may need to press the button a few dozen times).
- When the appliance goes off, press the button to confirm. Three long flashes indicate that the
operation has been completed successfully.
To command your appliances, you must programme your Speedy 2 COMBO as described in the next
paragraph. For those who can connect to the internet website www.meliconi.com, you will find interactive
instructions for a faster and easier programming of your remote control.
PREPARE FOR USE
Read these instructions carefully before programming your remote control!
- Turn on the appliance and select a programme.
- Simultaneously hold down the and buttons for 5 seconds until the upper indicator light starts to flash
indicating that the remote control is in the programming state.
- Release the buttons and enter the code 0001 within 12 seconds. The indicator light begins flashing more
quickly, indicating that the remote control is ready for the search.
- Point the remote control towards the appliance. Press and slowly release the button several times,
stopping when the appliance goes off (you may need to press the button a few dozen times).
- When the appliance goes off, press the button to confirm. Three long flashes indicate that the
operation has been completed successfully.
- Turn on the TV and select a programme.
- Turn on the TV and select a programme and buttons for 5 seconds until the upper indicator light
starts to flash indicating that the remote control is in the programming state.
- buttons for 5 seconds until the upper indicator light starts to flash indicating that the remote control is in the
programming state.
- Point the remote control towards the appliance. Press and slowly release the button several times,
stopping when the appliance goes off (you may need to press the button a few dozen times).
- When the appliance goes off, press the button to confirm. Three long flashes indicate that the
operation has been completed successfully.
If you have an analogue TV and an external decoder, follow procedure A and then procedure B. Follow procedure
C if you have a digital TV.
Additional check
Check that some of the other buttons, corresponding to those on your original remote control, work correctly.
If the commands function incorrectly or erratically, you have probably entered a code for a similar but different
remote control. In this case, repeat the search procedure starting from point 3.
ANALOGUE TV PROGRAMMING
DECODER PROGRAMMING
DIGITAL TV PROGRAMMING