Meliconi Control 2 digital CME User Manual

Page 4

DISPLAY CODE IN USE

If you set up the remote control using the

MANUAL SEARCH

procedure, obtain and make a note of the code in use as follows:
1. Press and hold down for 6 seconds the device selection

button corresponding to the device you wish to enter the

code for.

2. Release the button. The indicator light will fl ash. Press

the

TV / radio button for an instant.

3. After a pause of several seconds, the indicator light pro-

duces four sets of fl ashes, spaced out, corresponding to

the code to be obtained. Count the number of fl ashes.

Each set of fl ashes corresponds to one fi gure in the

code. Ten fl ashes correspond to the fi gure 0.

4. Make a note of the code obtained on the label on the in-

side of the battery cover. You may need it in future.

Code obtained =

1306

6 SEC.

ENTERING THE CODE DIRECTLY

(only to be performed if you know the specifi c code to be set)

If they do not appear, repeat the procedure. If the result is still negative, it means the code indicated

is not included in the remote control.

1. Press and hold down for 6 seconds the device selection

button corresponding to the device you wish to enter the

code for.

2. Release the button. The indicator light fl ashes.

Immediately enter the specifi c code previously found.

(e.g. 1306).

3. Three long fl ashes indicate a correct setting.

6 SEC.

NOTE: During the search the indicator stops fl ashing and the remote control exits the programming mode in the

following cases:
• if for 12 seconds the button indicated is not pressed or if another button is pressed
• if the list of codes to fi nd is terminated. In this case, visit the www.cme.it website.