Meliconi Control 2 digital CME User Manual

Page 3

NOTE: If you don’t receive an SMS on your cell phone or if the message says ERROR / NO CODE, it means the

system has not been able to process the data you have sent.

Do not try sending another SMS use the MANUAL

SEARCH instead.

SETTING CODES USING A MANUAL SEARCH

(only to be performed if the specifi c code could not be found)

CHECK

Check that the other buttons correspond to the functions of the original remote control; if not, it is likely that the code
found is incorrect, but is used for a very similar device. In that case, repeat the procedure from point 2.

If the manual search for the code is successful, obtain the code in use by following the DISPLAY CODE IN

USE procedure and make a note of it inside the battery cover.

1. Switch on the device to be programmed and select a pro-

gramme:

2. Press and hold down for 6 seconds the device selection

button corresponding to the device you wish to enter the

code for.

3. Release the button. The indicator light will fl ash. Point the

remote control at the device and press the

ON/OFF but-

ton. If the device does

NOT switch off, press the same

button again slowly (it may be necessary to press the

button several times).

4. When the device responds correctly, press OK. Three

long fl ashes indicate that the operation has been carried

out

correctly.

6 SEC.

Point the CME remote control at the device, which should already be ON and press the

ON/OFF button on the remote.

If the device does

NOT switch off, try setting the consecutive code in the SMS list on the remote control.

When the device reacts check whether the other buttons are operating correctly too.

If they do, the remote control is ready to use.

If they don’t,

you are probably using an incorrect code destined for a very similar device; at this point ignore the

SMS list and consult the

SETTING CODES USING A MANUAL SEARCH section to fi nd a more suitable code.