MEDC Expertline - Manual (Page 5)

Electric specifications
Operating voltage DC voltage 24 V
DC
± 20 %
The direct voltage at the terminals must amount to at least 19 V.
The voltage drop in the switched-on state on the lead-in wire
between the direct voltage source and the device must be taken
into consideration. The prospective short circuit flux I
K
of the external
power supply must not exceed 100 A.
Alternating current 230 V
AC
+10
- 20
%
red yellow green blue white
Power consumption 24 V
DC
Continuous light app. 480 mA app. 500 mA app. 680 mA app. 700 mA app. 720 mA
Blinking light app. 460 mA app. 480 mA app. 660 mA app. 680 mA app. 690 mA
Strobe light app. 850 mA app. 900 mA app.1200 mA app.1250 mA app.1280 mA
Rotating light app. 240 mA app. 240 mA app. 310 mA app. 310 mA app. 320 mA
Obstruction light app. 215 mA
– – – –
Power consumption 230 V
AC
Continuous light app. 47 mA app. 47 mA app. 55 mA app. 55 mA app. 55 mA
Blinking light app. 40 mA app. 40 mA app. 44 mA app. 44 mA app. 44 mA
Strobe light app. 37 mA app. 37 mA app. 40 mA app. 40 mA app. 40 mA
Rotating light app. 35 mA app. 35 mA app. 37 mA app. 37 mA app. 37 mA
Obstruction light app. 37 mA – – – –
Operating modes Continuous operation for all operating modes as per IEC34; DIN EN 60034-1; VDE 0530 Level S1
Continuous light
Blinking light
2 Hz
Strobe light 7x on and off then 1 sec. pause
Rotating light Approx. 111 rotations/min
Obstruction light Special construction, continuous light, colour red
Connecting terminals Supply voltage
Clamping capacity
4.0 mm² / the highest allowed current looping is 8 A at
2.5 mm² and 7 A at 1.5 mm²
Power cable cross section flexible to 2.5 mm² / AWG 24 - 11
Power cable cross section rigid to 4.0 mm² / AWG 24 - 12
Operating utilization position any
Operating conditions inside or outside
Housing Plastic Polycarbonate with stainless steel
wall bracket
Type Expertline-LED, Expertline-LED AC
Housing degree of protection IP 66 according to IEC 60529
Cable gland 1x M20 x 1.5 Power cable/wire Ø 5.5 to 13 mm
2x blind plugs M20 x 1.5
Temperature range Operation Storage
-40°C to +65°C / 24V
DC
-45°C to +80°C
-40°C to +60°C / 230 V
AC
Protection class III (24 V
DC
), II (230 V
AC
)
EC type examination BVS 09 ATEX E 092 X
certificate II 2G Ex e mb [ib] IIC T4
II 2D Ex mbD tD A21 IP66 T130°C
IECEx certificate IECEx BVS 09. 0048 X
Ex e mb [ib] IIC T4 Gb IP66
Ex mb t IIIC IP66 T130°C Db
ICAO certificate WSV ICAO Inspection sheet LS 83
(in the special construction with the LED colour red in operation type „obstruction light“
Weight Approx. 2.5 kg
5
Technical Specifications