MEDC FB11UL User Manual

Page 3

Once termination is complete, carefully push the cover assembly back onto the base,
avoiding damage to the mating surfaces. Replace the 6

off screws into the holes in the

cover assembly and tighten evenly. Ensure the required gap is maintained between the
cover and the base.

OPERATION
The operating voltage of the unit is stated on the unit label.
The beacon is powered directly only.

MAINTENANCE

During the working life of the unit, it should require little or no maintenance. However, if
abnormal or unusual environmental conditions occur due to plant damage or accident etc.,
then visual inspection is recommended.

If a unit fault should occur, then the unit can be repaired by MEDC. All parts of the unit are
replaceable.

If you acquired a significant quantity of units, then it is recommended that spares are also
made available. Please discuss your requirements with the Technical Sales Engineers at
MEDC.

SPECIAL CONDITIONS FOR SAFE USE

1. For replacement purposes the cover fixing screws shall be grade A2-70 or stronger.
2. When used in dust atmospheres, the flameproof cable entry devices or stopping plugs

shall be selected and installed to maintain the dust tight (IP6X) integrity of the
enclosure.

GENERAL ARRANGEMENT

11/14