beautypg.com

Marwin Valve 3T-3101 Series - 3-Way Brass Аква техника User Manual

Scope, Applicability, Caution

background image

3170 Wasson Road • Cincinnati, OH 45209 USA

Phone 513-533-5600 • Fax 513-871-0105

[email protected] • www.marwinvalve.com

I & M 3T3100/3L3200 Series

Installation & Maintenance Instructions for

Marwin 3T3100/3L3200 Series Three Way Ball

Valves

Warning: Marwin Valve ball valves must only be used, installed and repaired in accordance with these Installation & Maintenance

Instructions. Observe all applicable public and company codes and regulations. In the event of leakage or other malfunction, call a

qualified service person; continued operation may cause system failure or a general hazard.

Please read these instructions carefully!

Your Marwin Valve product will provide you with

long, trouble-free service if it is correctly installed

and maintained. Spending a few minutes now read-

ing these instructions can save hours of trouble

and downtime later. When making repairs, use only

genuine Marwin Valve parts, available for immediate

shipment from the factory.

Scope

This manual is intended as a guide to assist custom-

ers in the storage, installation, and maintenance of

Marwin 3T3100/3L3200 Series three way ball valves.

Subsequent additions or special instructions will be

provided for special ball valves, critical service or

customer requirements.

Applicability

This manual is applicable to the 3T3100/3L3200 Series

Marwin three way ball valves.

Caution

Valve pressure ratings are based on many vari-

1.

ables, including valve series and size, as well as

body, seat and bolt material. Verify that applica-

tion does not exceed the pressure or temperature

rating on the nameplate.

Always depressurize the line with the valve in the

2.

OPEN position before disassembly. Cycle valve in

depressurized line before removing valve.

Wear protective equipment and take appropriate

3.

precautions to safeguard against injury caused by

the discharge of trapped fluids.

Use only Marwin recommended spare parts for

4.

maintenance.

To ensure safety and maintain warranty, never

5.

modify valve in any way without prior approval from

Marwin.

Storage

A petroleum-based oil (silicone free) is used as lubrica-

tion on all internal surfaces. This may be removed with a

solvent if found objectionable. All valves are adequately

packed in a strong cardboard case in such a way as to

avoid any possible damage during transport and stor-

age.

Caution: if ball valves are not destined for immediate
use, the following precautions should be taken:

If possible, leave the ball valves in their packing

1.

cases during the period of storage.

Ball valves must remain in open position during this time.

2.

In order to prevent damage, protective plastic

3.

covers on valve ends should not be removed until

immediately prior to installation.

It is advisable to store the valves in waterproof con-

4.

ditions. Ball valves should be protected to safeguard

against humidity, moisture, dust, dirt sand, mud, salt

spray and seawater.

All valves complete with actuators are to be stored

5.

in dry conditions.

Valves to be stored for a long period of time should

6.

be checked by the quality control personnel every

six months; every three months when valves are

automated.

Maintenance During Storage Period

Internal surface should be inspected to check for

dust or other foreign objects.

Rust or dust must be removed by cleaning with

proper solvent.

After cleaning, ball valves must be lubricated with

an adequate lubricant.

Ball valves should be operated for at least two com-

plete cycles before installing or returning to storage.

This manual is related to the following products: