Marwin Valve CF8901 Series Three Piece Ball Valve - Manual

1
I & M CF8901 Series
3170 Wasson Road • Cincinnati, OH 45209 USA
Phone 513-533-5600 • Fax 513-871-0105
[email protected] • www.marwinvalve.com
Installation & Maintenance Instructions for Marwin
CF8901 Series Three Piece Cavity Filled Ball Valves
Warning: Marwin Valve ball valves must only be used installed and repaired in accordance with these Installation & Maintenance Instructions.
Observe all applicable public and company codes and regulations. In the event of leakage or other malfunction, call a qualified service person;
continued operation may cause system failure or a general hazard.
Please read these instructions carefully!
Your Marwin Valve product will provide you with long,
trouble-free service if it is correctly installed and
maintained. Spending a few minutes now reading
these instructions can save hours of trouble and
downtime later. When making repairs, use only
genuine Marwin Valve parts, available for immediate
shipment from the factory.
Scope
This manual is intended as a guide to assist
customers in the storage, installation, and
maintenance of Marwin CF8901 Series ball valves.
Subsequent additions or special instructions will be
provided for special valves, critical service or
customer requirements.
Applicability
This manual is applicable to the CF8901 Series Marwin
three piece ball valves
Caution
To help prevent injury to personnel or damage to
equipment, please read this section completely before
performing any operations.
1. Valve pressure ratings are based on many
variables, including valve series and size, as well
as body, seat and bolt material. Verify that
application does not exceed the pressure or
temperature rating on the nameplate.
2. Always depressurize the line with the valve in
the open position before disassembly. Cycle
valve in depressurized line before removing
valve.
3. Wear protective equipment and take appropriate
precautions to safeguard against injury caused by
the discharge of trapped fluids.
Use only Marwin recommended spare parts for
maintenance.
To ensure safety and maintain warranty, never modify
valve in any way without prior approval from Marwin.
Storage
No internal lubricant is used on these valves. An FDA
H-1 food grade incidental contact lubricant may be
used on the threads of the body-end cap bolts. All
valves are adequately packed in a strong cardboard
case in such a way as to avoid any possible damage
during transport and storage.
Caution: If ball valves are not destined for
immediate use, the following precautions should
be taken:
1. If possible, leave the ball valves in their
packing cases during the period of storage.
2. Ball valves must remain in open position during this time.
4” Size
½” - 3” Sizes