Electrolux LAVAMAT SOUPLESSE 14 - Manual (Page 49)

Setting up and connection instructions
49
Fitting under kitchen worktops
Important: The water supply tap and power outlet must remain acces-
sible after the appliance is installed.
If the appliance is connected to the mains through a permanent con-
nection, it must be separated at installation from the mains supply by a
dipole (N, L1) disconnector (for example, an Fi circuit-breaker) with a
break gap of > 3 mm.
The water and power connections must be placed to the side of the ap-
pliance. No room will be available behind.
Kitchen with worktops 85 cm high.
The washing machine can be installed in fully fitted kitchens with
continous worktops 85 cm high, after removing the machine's top
cover. This will reduce the height of the appliance to about 82cm.
To fit the washing machine, an adapter kit is required. These can be ob-
tained from Customer Service.
1 Warning! If removing the top cover to fit the machine,
– another protective cover must be mounted and, the appliance must
be earthed with special screws
– a replacement trim must be attached to the top front edge.
Then only should the appliance be connected electrically, and put into
operation.
The protective cover, special screws and replacement trim are included
in adapter kit.
Niche size requirements
(Measurements in mm)