Emerson Radio CKS5060S - Manual (Page 4)

3
• Operate controls and switches as
described in the manual.
• Before turning on the power, make
certain that the mains power cord is
properly installed.
• When moving the set, be sure to first
disconnect the mains power cord.
• Avoid installing this unit in places
exposed to direct sunlight or close to
heat radiating appliances such as
electric heaters, on top of other stereo
equipment that radiates too much
heat, places lacking ventilation or dusty
areas, places subject to constant
vibration and/or humid or moist areas.
CE Information
This equipment has been tested and found to comply with the EMC directive and
low voltage directive. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in
a particular installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
I M P O R TAN T N O T E S
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
CKS5060_090606.p65 6/9/2006, 9:46 3