beautypg.com

Echo HC-235 User Manual

Page 6

background image

6

An Emission Control Label is located on the engine.

(This is an EXAMPLE ONLY, information on label varies

by engine FAMILY).

e

mIssIoN

C

oNTRol

(

exhAusT

&

evApoRATIve

)

EPA 2010 and Later and/or C.A.R.B. TIER III

PRODUCT EMIssION DURAbILITy (EMIssION COMPLIANCE PERIOD)

The 50 or 300 hour emission compliance period is the time span selected by the manufacturer certifying the engine

emissions output meets applicable emissions regulations, provided that approved maintenance procedures are fol-

lowed as listed in the Maintenance Section of this manual.

The emission control system for the engine is EM (engine

modification) and, if the second to last character of the

Engine Family on the Emission Control Information label

(sample below) is “C”, “K”, or “T”, the emission control

system is EM and TWC (3-way catalyst). The fuel tank/fuel

line emission control system is EVAP (evaporative emis-

sions). Evaporative emissions for California models are only

applicable to fuel tanks.

WARNING

Moving parts can amputate fingers or cause severe injuries. Keep hands, clothing and loose objects away from all

openings.

ALWAys stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop

before removing obstructions, clearing debris, or servicing unit.

DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.

NEVER reach into any opening while the engine is running. Moving parts may not be visible through openings.

equIpmeNT

CheCk

WARNING

Use only ECHO approved attachments. Serious injury may result from the use of a non-approved attachment combi-

nation. ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which have

not been tested and approved by ECHO. Read and comply with all safety instructions listed in this manual and safety

manual.

• Check unit for loose/missing nuts, bolts, and screws. Tighten and/or replace as needed.

• Check that the cutting attachment is firmly attached and in safe operating condition.

WARNING

Check fuel system for leaks due to fuel tank damage, especially if the unit is dropped. If damage or leaks are found,

do not use unit, otherwise serious personal injury or property damage may occur. Have unit repaired by an autho-

rized servicing dealer before using.