Electrolux 65852 G - Manual (Page 20)

20
Seal Seal Seal Seal Seal
Fitting the Hob into the Worktop
Carry out the building in of the hob as
follows:
1. place the seals supplied with the
hob on the front edge of the cut
out. Then, place them at 11 mm
from the side edges and at 10
mm from the rear edge, as
shown in the diagram, taking
care that the seals meet without
overlapping.
2. Place the hob in the cut out, taking
care that it is centred.
3. Fix the hob with the relevant fixing
clamps, supplied with the
injectors kit (see diagram). When
the screws have been tightened,
the excess seal can be removed.
The edge of the hob forms a double seal
which prevents the ingress of liquids.