EPoX Computer BT-PA02A - Manual (Page 3)

PA02AA0 REV 1.0 602A002P2A100 ~3~
C. PRINTER ADAPTER HARDWARE INSTALLATION
Plug the EPoX USB Printer adapter into the USB printer port of
your printer as shown below. Now, your printer has become
Bluetooth enabled. Congratulations!!
1.Plug BT-PA02A into the printer port.
2.Plug the power into the BT-PA02A
"
Note: Please do not use any other power adaptor with the
EPoX USB Printer Adaptor (BT-PA02A). If you have
problems, contact your dealer for a replacement.
D. ESTABLISHING A CONNECTION
To establish the Bluetooth connection, you have to configure
the serial port setting on the Bluetooth device. If your Bluetooth
device is an EPoX BT-MB02B or BT-DG02 or BT-DG03 or BT-DG02A,
after the Widcomm protocol stack is installed, then follow the steps
below. If your Bluetooth device is other than EPoX, please contact
your manufacturer to obtain more information.
D.1: Checking the COM port used by BT-PA02A EPoX Bluetooth
USB Printer Adapter: