Powerfix Z29948 - Manual (Page 10)

10 GB
Using the Multifunction Detector
Tip! Test the device before initial use on a metal pipe
or power line whose position you know exactly.
Slide the function switch 3 to “METAL” in order to
locate metal pipes etc.
Slide the function switch 3 to “VOLTAGE” in order to
locate power lines etc.
Keep the detector at a distance from metals and from
live cables.
Afterwards, press and hold down the PUSH button 4 .
Point the measuring head 1 directly towards the
desired place on the wall while holding down the
PUSH button.
Move the device slowly over the wall surface.
Note: Ensure direct contact between the measuring
head
1 and the wall.
Once the device locates metal or power lines, the red
LED 2 flashes. A beep is also heard. The closer you
move the device to metal or power lines, the faster the
red LED
2 flashes and the more frequently the beep
is heard. If there are power lines or metal in the imme-
diate vicinity, the red LED
2 lights up permanently.
The beep sounds continuously.
Release the PUSH button 4 in order to stop the
measurement.
Trouble-shooting
= Error
= Problem
= Solution
No beep is heard when metal or power
lines are in the immediate vicinity.
The batteries are flat.
Change the batteries (see ”Inserting / changing the
batteries”).
Cleaning and Maintenance
Clean the outside of the device only with a soft,
slightly moist cloth. Never use liquids or cleaning
agents, as they may damage the device.