Cleaning and care – Silvercrest SMA 550 A1 User Manual

Page 55

SMA 550 A1

Cleaning and Care

DANGER - RISK OF ELECTRICAL SHOCK!

►

Before cleaning it, disconnect the plug from the mains power socket!
Otherwise there is the risk of receiving an electric shock!

►

NEVER open any housing parts. There are no user-serviceable elements
inside. When the housing is open, there is the risk of receiving a potentially
fatal electrical shock.

NEVER immerse the appliance in water or other liquids! This would

bring about the risk of a potentially fatal electric shock upon the
next use of the appliance should moisture be present in the voltage
conducting elements.

WARNING - RISK OF PHYSICAL INJURY!

►

Let the appliance cool down before cleaning it. Risk of burns!

WARNING - PROPERTY DAMAGE!

Do not clean the appliance or parts of it in the dishwasher!
If you do so, the appliance will be damaged beyond repair.

►

Do not use abrasive or caustic cleaning agents. These can attack the
surface and damage it beyond repair.

NOTICE

►

Ideally, clean the appliance directly after cooling, so that milk residues can
not dry onto it.
For the ﬁ rst coarse cleaning put some water and a little mild detergent into
the carafe (the whisk used 4/8 is still ﬁ tted). Thereby, pay heed to the
MIN and MAX

- markings.

Start the appliance so that the whisk ploughs 4/8 through the water.
Afterwards, rinse the appliance out with copious clean water.

For a thorough cleaning, proceed as follows:

■

Remove the whisk 4/8 from the appliance to clean it and clean the inside
of the appliance with warm water. Add a little detergent. Wipe the interior
with a soft cloth or sponge. Pay special attention to the area around the
drive shaft. Afterwards, rinse the appliance out with copious clean water.

■

Pull the sealing ring 3 oﬀ of the lid 1 and clean both parts in mild soapy
water. Remove detergent residues with clean water and dry both parts well.
Push the sealing ring 3 back onto the lid 1, so that the outwardly facing
sealing lip is located at the bottom of the lid 1 and the inwardly facing seal-
ing lip engages in the groove of the lid 1.

IB_100076_SMA550A1_CH.indb 52

01.04.14 16:40