Silvercrest SHBS 500 B1 - Manual (Page 67)

65 GB
just the cutting length with the slider10 and read off the cutting lengths on
the marking8 on the side of the comb attachment1.
• Start by cutting the hair in the neck or on the sides and cut towards the cen-
tre of the head. Then, cut the front section of the hair towards the centre of
the head.
• Hold the device in such a way that the comb attachment lies as flat as pos-
sible on the head. Move the device evenly through the hair.
• If possible, cut against direction of hair growth.
• In order to catch all the hair, move the device several times through each
section of the hair.
• Comb the hair repeatedly and well.
• In order to achieve a straight cutting line for cutting lengths over 20 mm,
the device should be passed through the hair several times from different di-
rections.
6.3 Thinning hair
Use the thinning function to reduce the volume of the hair without changing its
length.
•
Push the slider3 to the left. The thinning function integrated into the shav-
ing head9 is extended upwards.
6.4 Cutting hairlines and beard
WARNING! Risk of injury!
The points of the shaving head are sharp. Handle with care.
• Adjust the cutting length with the slider10 according to the desired hair
length and read off the cutting length using the marking8 on the side of
the comb attachment1. Now, shorten your beard step-by-step.
• Use the device only with the shaving head9 and without comb attach-
ment, to cut hair very short or to cut beard and hairline. In this way you
can cut hair lengths of 1-2 mm evenly.
__GRA93480_B1.book Seite 65 Montag, 9. September 2013 10:20 22