Assembly/disassembly, Operation – Silvercrest SHSS 12 A1 User Manual

Page 38

SHSS 12 A1

GB
MT

Assembly/disassembly

Floor nozzle

■

Attach the ﬂ oor nozzle to the handle so that the
connection plug of the ﬂ oor nozzle u engages
with the connection socket i on the handle.

■

To remove the ﬂ oor nozzle, simply pull it from
the handle.

Connecting the hand element to the
handle/removal from handle

Fig. 1

Fig. 2

■

To connect the hand element 5 to the handle,
push the tip of the hand element 5 into the
opening in the hand element recess r.

■

Then press the grip 1 of the hand element 5
into the handle so that the hand element 5
clicks ﬁ rmly into position (Fig.1).

■

To remove the hand element 5 from the handle,
press the "Hand element" release w.

■

Then pull the hand element 5 upwards and for-
wards out of the hand element recess r (Fig. 2).

Operation

ATTENTION! DAMAGE TO PROPERTY!

►

The suction opening must always be open and
unblocked. Blockages lead to overheating
and damage to the motor.

►

Do not vacuum shag pile carpet with the ﬂ oor
nozzle. The rotary brush t can get caught in
the carpet and block!

NOTE

►

Make certain that the dust ﬁ lter 7 and the
coarse ﬁ lter 8 are always inserted before
using the appliance.

►

As soon as the suction power of the appli-
ance begins to diminish noticeably, connect
the appliance to the charger p.

Using the hand element with the
handle

1) Insert the hand element 5 into the hand

element recess r as described in the chapter
"Assembly/disassembly".

2) Fold out the grip 0 by pressing the "Grip"

release q and at the same time pulling the
grip 0 upwards. You have the choice of two
positions into which the grip 0 will click into
place.

3) Attach the ﬂ oor nozzle.

4) Switch on the appliance using the on/oﬀ

switch 2. The operating light z on the ﬂ oor
nozzle will light up and the rotary brush t
starts turning.

5) Guide the ﬂ oor nozzle over the area to be

vacuumed. Hold the grip 0 so that the ﬂ oor
nozzle moves smoothly over the ﬂ oor.

6) Set the on/oﬀ switch 2 to "O" when you have

ﬁ nished vacuuming. The rotary brush t stops
turning and the operating light z goes out.