Silvercrest SHG 35 A1 - Manual (Page 25)

25 GB
Important safety instructions / Before use / Start-up
electrical circuit. Ask your electri-
cian for advice.
Only connect the hair straightener
to a socket matching the voltage
specified on the nameplate.
Never open the hair straightener
or attempt to repair the hair
straightener yourself. Any modifi-
cations will void the warranty.
Only unplug the power supply
7
from the socket by the mains plug.
Discontinue use of the hair
straightener if it has been dropped
or otherwise damaged.
Untangle the power cord
7
if it
becomes twisted.
Do not use any additional parts,
which have not been recom-
mended or supplied as accesso-
ries by the manufacturer.
Repairs may only carried out only
by qualified specialist personnel
or in a workshop approved by
the manufacturer. Improper re-
pairs may result in considerable
danger for the user.
Before use
Note: The hair straightener may become
very hot depending on the time used.
Only touch by the handle when hot.
There is a risk of fire and burns. Do not touch the
heating plates
1 .
Note: Switch the device off immediately if defective
or malfunctions occur.
Ensure that you are standing on a dry, electri-
cally non-conductive floor surface.
Ensure that your hands are dry.
Untangle the power cord
7 , if this becomes
twisted.
Do not pull, twist or bend the power cord 7 ,
and do not run / place on sharp, pointy objects
or hot surfaces.
Do not catch the power cord 7 in e.g. drawers
or doors.
Be sure your hair is dry.
Unlock the hair straightener by the plates lock
4 .
Connect the hair straightener to the mains.
Set the On / Off switch
3 the „I“ position.
The flashing operation indicator 2 means the
appliance is heating up.
Wait 60 seconds for the hair straightener to
heat up. Once the operation indicator 2 stays
on the appliance is ready for use.
Start-up
Dry your hair completely before using the hair
straightener.
Note: Hair should be clean and free of styling
products. This does not include special products
with assist in straightening hair.
Comb your hair with a wide tooth comb to
detangle.
Divide your hair into individual sections appro-
ximately 3 to 4 cm wide. Hold the section taut
and place the hairline between the heating
plates
1 .
Slowly and evenly move the hair straightener
from the hairline to the ends.
Note: Do not keep the hair straightener in one
area more than two seconds. This will provide
the best results without placing too much stress
on the hair or damaging it.
Note: To shape the ends, turn the hair straigh-
tener either inward or outward before drawing
it across the ends.
Safety shut-off:
The hair straightener features a safety shut-off. After
approx. 30 minutes without the on / off switch
3