beautypg.com

Silvercrest SHG 35 A1 User Manual

Page 24

background image

24 GB

Important safety instructions

and make sure that you pass on
this manual together with the hair
straightener.

RISK

OF FATAL INJURY

AND ACCIDENTS FOR TOD-

DLERS AND CHILDREN!
Never leave children unattended
with the packaging material.
Suffocation hazard.

RISK OF

ELECTRIC SHOCK AND IN-

JURY! Do not expose the hair
straightener to shock and do not
drop. Carefully check the hair
straightener, mains plug and the
power cord

7

for signs of wear

and / or damage before every
use. Do not use the hair straight-
ener if you see signs of wear or
damage, or if the hair straightener
was used improperly, and switch
it off immediately in the event of
defects or malfunctions. In this
case, return it to the dealer before
using it again. There is a danger
of electric shock and injury.

Do not improperly use the

power supply

7

to carry,

hang up or to unplug the hair

straightener from the mains. Do
not allow the power cord

7

to

become trapped, kinked or twisted.
Keep the hair straightener and

power cord

7

away from heat,

oil and sharp edges. If the power
cord

7

is damaged or severed,

do not touch the power cord

7

,

but pull the mains plug out of the
socket immediately. Damaged or
tangled power cords

7

increase

the risk of electric shock.

FIRE HAZARD! Do not
cover the hair straightener.

There is a fire hazard!

FIRE HAZARD! Do not
use the hair straightener

on artificial hair. There is a fire

hazard.

Do not use any extension cables

in the bathroom, so that in an
emergency the mains plug can
be reached quickly.

When using the hair straightener

in the bathroom, unplug after
use as the proximity of water
presents a hazard, even with the
hair straightener switched off.

Never immerse the hair straight-

ener in water. Never reach for a
device which has dropped into
water and is still connected to
the mains socket. Unplug imme-
diately. For added protection we
recommend installing an earth
leakage circuit breaker (ELCB)
with a rated trigger current not
to exceed 30 mA into the