Silvercrest SWKS 2200 B1 - Manual (Page 39)

37 GB
9. Disconnect the mains plug6 from the
wall socket.
10.Remove the kettle2 from the device
base4 and pour the water out.
8. Cleaning
DANGER! Risk of electric
shock!
~ Pull the mains plug6 out of the wall
socket before you clean the kettle2.
~ The kettle2, the device base4, the
power cable and the mains plug6 must
not be immersed in water or other liq-
uids.
DANGER! Risk of injury
through scalding!
The kettle2 becomes very hot during opera-
tion. Allow it to cool down before cleaning.
WARNING! Risk of material damage!
Do not use any astringent or abrasive clean-
ing agents.
After every use
Clean the device after every use, if possible.
1. Disconnect the mains plug6 from the
wall socket.
2. Wipe the kettle2, the device base4
and the power cable6 with a damp
cloth if necessary. Dry with a dry cloth.
3. Allow all parts to dry completely before
you put them away or use the device
again.
NOTE: the kettle2 can also be cleaned on
the outside with stainless steel cleaners from
specialist retailers.
Cleaning the limescale filter
1. Open the lid9.
2. Pull the limescale filter1 off upwards
from the kettle2.
3. Clean the limescale filter1 with a moist
dishcloth under running water.
4. Slot the limescale filter1 into the intend-
ed fitting in the kettle2 and press it
downwards.
Descaling
After some time, the boiling process will re-
sult in limescale being deposited in parts of
the kettle (depending on the hardness of the
water used). You should remove this at regu-
lar intervals, because otherwise the power
consumption of the device will increase.
1. Pull the limescale filter1 off upwards
from the kettle2. If there is limescale
residue in the limescale filter1, place it
in the kettle when descaling.
2. Fill the limescale remover into the ket-
tle2. Use a commercially available li-
mescale remover, e.g. limescale
remover for coffee machines. Comply
with the instructions on the packaging
of the limescale remover. You can find
the next steps in the instructions of the li-
mescale remover. Rinse the kettle multi-
ple times after descaling, if necessary.
3. After descaling, rinse the limescale fil-
ter1 well. Slot it into the intended fitting
in the kettle2 and press it downwards.
Time intervals for descaling
The intervals for descaling are dependent
on the hardness of the water, and how often
you use the device. Where the hardness of
the water is medium or high, we recommend
descaling monthly.
If using tap water, you can find out the hard-
ness of the water in the area where you live
by inquiring at your local waterworks.
__RP106104_B1.book Seite 37 Donnerstag, 9. Oktober 2014 2:31 14