Silvercrest SWKS 2200 B1 - Manual (Page 38)

36 GB
5. How to use
DANGER! Risk of electric
shock!
~ Only connect the device to an easily ac-
cessible wall socket whose voltage cor-
responds to the specifications on the
rating plate. The wall socket must contin-
ue to be easily accessible after the de-
vice is plugged in.
~ Pull the mains plug6 out from the wall
socket after every use.
• Remove all packing material.
• Check to ensure that all parts are pre-
sent and undamaged.
• Place the device on a dry, level, non-slip
surface.
6. Before using for the
first time
1. Fill the kettle2 up to the marking
MAX 1.7L on the water level display3
and heat the water (see “Using the kettle”
on page 36).
2. Pour the water out and rinse out the ket-
tle2 with fresh water.
3. Repeat this process. Then it is safe to
use the device.
7. Using the kettle
DANGER! Risk of injury
through scalding!
~ It is always necessary to close the lid9
when heating water, as boiling water
may otherwise spray out!
~ Do not open the lid9 while the water is
boiling.
~ Fill the kettle2 only to the maximum fill-
ing level (MAX 1.7L), as boiling water
may otherwise spray out.
~ Do not bend over the kettle2 when you
open the lid9 and the contents are still
hot. There is a danger of being scalded
by escaping steam.
~ The kettle2 becomes very hot during
operation. Only touch it at its handle7
and only use the release button8 and
the on/off switch5.
WARNING! Risk of material damage!
~ Fill the device with a minimum of 0.7 li-
tres of water, as otherwise the device
may overheat.
~ Never put alcohol, sugar or milk into
the kettle2!
Water as foodstuff
Water is a very sensitive foodstuff and can go
bad due to germs forming. Please take note:
• Always use fresh drinking water in the
kettle2.
• Pour water away, which has been
standing in the kettle2 for longer than
approx. 1 hour.
• Do not reboil cooled down water.
Boiling water
1. Remove the kettle2 from the device
base4.
2. Press the release button8 to open the
lid9.
3. Fill the desired amount of fresh drinking
water into the kettle2. Keep it upright
or place it on an even surface to be
able to read the water level display3
correctly.
4. Close the lid9, by pressing it down-
wards.
5. Place the kettle on the device base4.
6. Insert the mains plug6 into a wall sock-
et corresponding to the technical data.
7. Press the on/off switch5 down, until it
lights up blue and locks into place.
8. The device automatically switches off as
soon as the water starts to boil.
__RP106104_B1.book Seite 36 Donnerstag, 9. Oktober 2014 2:31 14