Silvercrest SHS 12.0 A1 - Manual (Page 26)

26 GB/MT
Warranty and Service / Declaration of Conformity / Manufacturer Operation / Servicing and cleaning / Disposal
Insert the small brush 7 snugly into the front
nozzle 4 .
Crevice tool 8 :
Use this attachment to get into narrow, difficult­to­
access places.
Insert the crevice tool 8 snugly into the front
nozzle 4 .
removing attachments:
Simply pull the attachment off the front nozzle 4
or the extension hose 5 .
Q Switching on / off
Insert the 12 V plug 3 into the 12 V socket /
cigarette lighter socket of the vehicle, see Fig. C.
To switch the device on, press the ON / OFF
switch
2 forwards into the ON position.
To switch the device off, press the ON / OFF
switch
2 back into the OFF position.
Pull the 12 V plug 3 out of the 12 V socket
after use.
tip: If you going to vacuum for a long period, we
recommend that you carry out the cleaning with
the engine running.
Q Fastening the storage bag to a
surface in your car boot
You can fasten the storage bag 9 in a suitable
place, e.g. in the boot of your car. To do this,
press the bag lightly against a suitable textile
surface in your vehicle, for example the back
of the rear seats. The storage bag
9 is held in
place by two hook and loop fastening strips.
Q Servicing and cleaning
The device requires no maintenance.
AttEntIon! Before you clean the device
itself, pull the 12 V plug
3 out of the 12 V
socket, otherwise there Is a risk of electric shock.
Clean all the housing with a soft, dry cloth.
Never use liquids or cleaning agents, as they
may damage the device.
For the best possible performance, you should
empty the dust container
10 immediately after
use and when the suction power drops.
Press the unlocking button 1 and take the
dust container 10 out of the housing 12 .
Take out the dust filter 11 . You will be able to
clean the dust filter better if you detach it from the
end seal. To do this, hold the end seal firmly
and twist the filter off carefully anticlockwise
(bayonet fitting). Rinse out the dust filter
11
thoroughly in cold water and allow both parts
(filter and end seal) to dry completely. Attach
the filter back on to the end seal.
Empty the dust container 10 completely.
Carefully replace the dust filter 11 back into
the dust container 10 . Never use the vacuum
cleaner without the dust filter 11 in place.
Attach the dust container 10 carefully back
on to the housing 12 and ensure the two parts
engage.
AttEntIon! The front nozzle 4 must be free
and unobstructed at all times. Blockages can lead
to overheating and damage to the motor.
Q Disposal
The packaging is composed of environ­
mentally­friendly materials that can be
disposed of at a local recycling centre.
Do not dispose of electrical
devices with the household
rubbish!
In accordance with European Directive 2002 / 96 / EC,
worn out electrical devices must be collected
separately and taken for environmentally compatible
recycling.
Contact your local refuse disposal authority for
more details of how to dispose of your worn out
electrical devices.