Silvercrest Z31123 - Manual (Page 64)

64 GB/MT
=
= The scale is overloaded.
= Remove the overload.
= stays on in the LC display.
= The overload has caused a malfunc-
tion of the weighing process.
= Switch the scale off and then on again.
=
= The batteries are too weak. You can-
not bring the scale into use.
= Replace the batteries (see section
“Inserting / replacing batteries“).
= The device cannot be switched on.
= The batteries may be spent.
= Exchange the batteries (see section
“Inserting / replacing batteries“). If
the device still cannot be switched on,
please contact the service centre.
Note: This device has delicate electronic
components. Therefore interference may
occur when it is near devices which trans-
mit radio signals.
If errors occur in the display, remove any
such devices from the vicinity of the product.
In the case of such malfunctions, remove
the batteries briefly and then insert them
again.
Cleaning
Clean the product using a slightly moist,
fluff-free cloth.