Silvercrest Z31123 - Manual (Page 62)

62 GB/MT
Press the ON / OFF / TARE switch
while the weight is being displayed to
reset the display to “0.00 kg / 0.0 lb“.
You will hear a signal. Now you may
start another weighing process.
Press the ON / OFF / TARE switch
and hold for approx. 3 seconds to
switch off the device. After switching
off, a signal tone is sounded.
Changing the unit
of weight
Press the ON / OFF / TARE switch 5
and hold while the device is switched
off.
Release the ON / OFF / TARE switch as
soon as “0.00 kg / 0.0 lb“ appears in
the LC display 6 . The weight unit 8
“kg“ or “lb“ blinks.
Press the ON / OFF / TARE switch to
select between the units.
Note: If you do not press the
ON / OFF / TARE switch for more than
approx. 3 seconds, the device always
saves the setting that was made.
Begin the weighing process as
described in section “Weighing“.
Troubleshooting
= Fault
= Reason
= Solution