Emerson Process Management ITONE IC200 - Manual (Page 28)

2 7
4.) After installing the necessary adapter in the docking area and making sure that
it is locked in place, mount the support bracket, and then your iPod ® into the
adapter so that the 30-pin connector in the docking area is fully inserted into
the 30-pin socket on the bottom of your iPod ® .
If necessary set the HOLD switch on your iPod ® to the “Off” position.
5.) Press the Power button on the top panel or remote control to turn this system
‘On’. Depending on the setting of the Back Light Timer in your iPod ® the display
backlighting may turn ‘On’ and the “Charging” or “Charged” indicator will appear
in the display.
6.) Press the Function button on the
top panel or on the remote control
to select the iPod function.
Your iPod ® will begin to play. It may begin playback with the first song in your
library in alphabetical order by song name, or if the iPod ® was only shut off for
short time it may begin playback of the same song that was playing before it
was shut off.
NOTE: If the Power of this system is ‘On’ and the iPod function is already
selected then your iPod ® will begin to play as soon as it is connected to the
dock, as long as the iPod ® HOLD switch is ‘Off’. If your iPod ® enters the Pause
mode when you connect it to the dock, press the Play/pause button to
begin playback.
iC200_052906.p65 29/5/2006, 10:29 27