Emerson Process Management ITONE IC200 - Manual (Page 22)

2 1
4.) If you tuned to an FM Stereo
station the FM ST. indicator
appears in the display.
5.) A few seconds after you release the tuning controls the display changes from
radio frequency back to the correct time. To see the station frequency again,
press the Time button on the top panel. The display will change from time to
radio frequency for a few seconds and then return to the correct time again.
6.) Adjust the volume to the desired level by pressing the Volume + or – buttons
on the top panel or the remote control. The volume level appears in the display
when the volume is adjusted.
The display level ranges “00” (minimum) to “63” (maximum).
7.) When you are finished listening press the Power button on the top panel or
the remote control to shut the system ‘Off’. The TUNER indicator goes off.
NOTE: The Tuner remembers the last station that you were listening to and
the selected volume level, and automatically returns to the same station and
volume level when the system is switched ‘On’ again.
iC200_052906.p65 29/5/2006, 10:29 21