Silvercrest SFR 1200 A1 - Manual (Page 41)

41 GB/MT
Cleaning and maintenance / Disposal
Wet cleaning:
CAUTION! Above a temperature of about
45 °C there is the risk of scolding injury. Set your
mixer tap to a lower temperature or ensure that no
hot water can come into contact with your hands
or arms.
The shaving head
9 and cutter set 12 can be
washed under lukewarm to hot running water
(max. 70 °C):
Press the release button 6 : The shaving head 9
flips up (see Fig. A).
If necessary add some liquid soap.
Switch on the device during washing to achieve
a more intensive cleaning action (cordless op-
eration only).
Wipe the housing with a soft, slightly moistened
cloth.
Allow the shaver and cutting parts to dry.
CAUTION! In order to avoid accidents, do not
use force when attaching the shaver head 9
and do not press down on the shaving foil 4 !
Hold the sides of the shaver head 9 and press
it down until it clips into place.
Replace the protective cap 2 .
Maintenance
Check cutting parts and replace
if necessary
The quality of the shave is largely affected by the
condition of the cutting parts. As they are subject to
natural wear and tear, you must replace them in
due time.
As both cutting parts adapt themselves to each other
over time, we recommend that you replace the shav-
ing foil
4 (as a unit with the shaving foil frame 3 )
and the cutter set 12 at the same time. You can
easily order these replacement parts through our
Service Centre (see Service Hotline on the accom-
panying guarantee sheet).
RISK Of INjURy fROM
SHARP CUTTING EDGES!
CAUTION! In order to avoid injuries, do not
press down on the shaving foil 4 when fitting
it! Replace bent or damaged foils!
Press the release buttons 5 on the sides and
pull the shaving foil frame 3 off upwards.
Take hold of the cutter set 12 at both ends and
pull off upwards.
Insert the new parts in reverse order.
CAUTION! In order to avoid injuries, you
must allow the cutter sets 12 click into place!
Holding only the sides of the shaving foil
frame
3 , push down until it clips into place.
Disposal
You are not permitted to throw away
single-use or rechargeable batteries with
household refuse. Please dispose of single-
use or rechargeable batteries through a
battery return system or a battery collection
point run by your dealer or local council.
When you decide to discard the device,
please do not place it (even without bat-
teries) into the household refuse bin.
Contact your local council to find out about
environmentally friendly and proper dis-
posal of the device as electrical scrap.
The packaging consists of environmentally-
friendly materials which you can dispose
of at your local recycling points.
Removal of rechargeable
batteries
In order to avoid injuries, do
not operate a disassembled appliance! Do not
short-circuit any rechargeable batteries you remove
from the appliance; they could become very hot if
they are still charged!