Silvercrest SBTF 10 B2 User Manual

Page 13

SBTF 10 B2

Note:

Voice dialing is only available with mobile telephones that
support this function. Further information regarding voice
dialing is to be found in the operating instructions for your
mobile telephone.

Accepting and ending a call

When you receive a call the LED status display 6 blinks
and you hear a call tone from the hands-free appliance.
If the call signal in your mobile phone is switched oﬀ , the
ringing tone is nonetheless sounded via the hands-free
appliance.

●

Press the multi-function button 7 shortly once,
to accept the call.

●

Press the multi-function button 7 shortly once,
to terminate the accepted call.

You can also accept and terminate the call over the
mobile telephone.

Automatic call acceptance

If automatic call acceptance is activated in the mobile
telephone, it accepts the incoming call after a determined
time period and then passes it on to the hands-free
appliance. Further information regarding automatic call
acceptance is to be found in the operating instructions for
your mobile telephone.

Rejection of a call

●

Press the multi-function button 7 for 3 seconds to
reject an incoming telephone call.

Adjusting the volume of the hands-free appliance

You can adjust the sound volume level of the hands free
device with the +/- buttons 3.

●

During a call, repeatedly press the + resp. - buttons 3
until the desired sound volume level is obtained. The
attainment of the maximum sound volume level is indi-
cated by a short signal tone.

IB_78534_SBTF10B2_LB4.indb 10

20.08.12 09:21