Silvercrest SSMK 40 B2 - Manual (Page 26)

26 GB/MT
After use, switch off the shiatsu cushion by
pressing the On /Off button
5 .
Back massage:
Select with button A+B 7 , A 8 or B 9 the
area you would like to have massaged:
A+B: your whole back
A: upper back
B: lower back.
The LED lamp signalises the massage area that
has been set.
note: When you select the massage area, the
automatic switch-of will be activated and set at
15 minutes.
Press the timer button 10 , employing the appro-
priate frequency, to set the automatic switch-off
at 5, 10 or 15 minutes.
note: by resetting the timer setting, the timer will
begin counting anew. At the beginning of the
massage, select the maximum duration of the
massage and do not change this during the
massage in order to prevent the shiatsu cushion
from overheating.
note: Ensure that you are experiencing the
massage as pleasant and relaxing. If necessary,
vary the pressure and/ or your position. Stop the
massage at once if it is painful or unpleasant.
Heating function:
Press the heat button 6 , to activate the heating
function.
Press the heat button 6 once again to deacti-
vate the heating function.
note: The heating function cannot be activated
unless a massage program has been previously
selected.
Seat vibration:
Press the seat vibration button 11 to activate
the seat vibration. The vibration starts at a low
intensity and the relevant LED for seat vibration
will light up.
Press the seat vibration button 11 , with the
appropriate frequency, to switch to low,
medium or high intensity or to deactivate the
seat vibration.
note: The seat vibration can be activated
together with the back massage. However, the
vibration intensity will be slightly reduced in
this case.
Demonstration:
Press the Demo button 12 to have the functions
of the shiatsu cushion demonstrated to you.
troubleshooting
Problem
Cause
Rectification
Massage heads rotate slower and slower.
Too much pressure on massage heads.
Relieve pressure on massage heads.
Massage heads do not move.
shiatsu cushion is not connected to the mains
supply.
Insert the plug and switch on the cushion.
shiatsu cushion is not switched on.
Switch on the shiatsu cushion by pressing the
On /Off button 5 . Select the massage area.
The transportation lock has not been removed.
The massage mechanism is damaged.
Contact your specialist dealer or the service ad-
dress.
Cleaning and Care
DAnGeR to
LIfe BY eLeCtRIC SHoCK!
Always disconnect plug from the
mains socket before cleaning the shiatsu seat
cushion. Otherwise there is a risk of electric
shock.
DAnGeR of eLeCtRIC SHoCK!
Do not pull the cover
2 over the
cushion until it is completely dry.
Otherwise there is a risk of electric shock.
CAUtIon! DAnGeR of MAte-
RIAL DAMAGe! Do not use chem-
ical cleaners or scouring agents for
Bringing into service / operation / Troubleshooting / Cleaning and Care