Silvercrest SFR 2.4 B1 - Manual (Page 95)

SilverCrest SFR 2.4 B1
English 93
Powering the Transmitter Cradle Using Batteries
The transmitter cradle battery compartment (19) is located on the bottom.
1. Remove any cable connections and turn the transmitter cradle upside down, holding it in your
hand.
2. Open the battery compartment by sliding the lock of the compartment cover into the direction
of the compartment. The cover can be opened and then removed.
3. Insert three AAA batteries into the battery compartment. Note the + and – icons on the
batteries and inside the battery compartment.
4. Place the battery compartment cover over the battery compartment so that the locking nose of
the cover is inserted into the corresponding notch on the transmitter cradle. Then close the
battery compartment cover until it locks in place.
If you have inserted batteries into the transmitter cradle and you connect the
power adapter to the power socket (15), battery operation will be disabled
automatically. This helps you to save battery power whenever the device is
connected to the mains via the power adapter.
While the transmitter cradle is on battery power, it will not charge the built-in
headphone battery.