Earlex HV2900 - Manual (Page 3)

SAFETY OPERATING INSTRUCTIONS
PLEASE READ BEFORE USE
• Never under any circumstances aim the Spray Gun at another person or animal. In the event of injury occurring seek expert medical advice
immediately.
• The Spray Gun must only be used with paints and solvents that have a flash point suitable for spraying. If in doubt, consult the paint or solvent
manufacturer’s data.
• Always ensure there is adequate ventilation when spraying.
• NEVER spray near a naked flame, including appliance pilot light.
• NEVER smoke whilst spraying.
• NEVER allow children to operate or play with the Spray Gun.
• Always read the solvent manufacturer’s instructions before use.
• Always disconnect unit from mains supply when filling the paint container.
• Always wear a suitable protective mask when spraying. We would also recommend the use of gloves, goggles and overalls.
• After each use, thoroughly clean the Spray Gun.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience
and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
• Use only genuine manufacturer replacement parts.
• Always disconnect the Spray Station from the mains supply before cleaning the appliance.
• Warning: The use of any accessory or attachment, other than those recommended in this instruction manual, may present a risk of personal
injury.
• Use the Spray Gun for the job it was designed for only. Mis-use of the Spray Gun will invalidate the guarantee.
• Wear ear protection.
WARNING: The substances used with this Spray Gun (paints, solvents, etc.) may contain dangerous, harmful, explosive or corrosive
materials. ALWAYS COMPLY WITH THE SAFETY INSTRUCTIONS ISSUED WITH THIS PRODUCT AND THE MATERIAL BEING USED.
3
PARTS LIST
No.Description Part Code
1. Needle and Fluid Tip Tool V0018
2. Air Cap Ring V0001
3. Air Cap V0002
4. Spray Direction Plate V0003
5. Fluid Tip 2.0mm V0004
6. Fluid Tip O-Ring V0005
No.Description Part Code
7. Fluid Needle 2.0mm V0006
8. Lip Seal - Fluid Needle V0007
9. Paint Flow Adjuster V0011
10. Paint Container Seal L0682
11. Pick-up Tube V0012
12. Paint Container V0014
Fig.1
PARTS LIST HV3500
Fig.2
INTRODUCTION
The concept
A motor feeds out a high volume of air (HV) and enables products to be sprayed at a low pressure (LP). The Hose feeds the air produced by the
motor to the Spray Gun. The solution is released from the Fluid Tip of the Spray Gun at a very low pressure and is enclosed in a high volume of air.
The powerful motor can spray a wide range of solutions with or without dilution. However, there will always be some which will not be suitable for
the Spray Gun. Good quality paint contains a high percentage of solids which make the dilution easier. The users must keep in mind that low
temperatures make the paint thicker, that’s why we recommend spraying with the Spray Gun at a 15°C minimum temperature.
No.Description Part Code
13. Hose L1064
14. Filter L0290
No.Description Part Code
13. Hose L0896
14. Filter L0290
PARTS LIST HV2900/3900
Fig.3