Silvercrest SKHD 1800 A1 - Manual (Page 11)

SKHD 1800 A1 9
7.5 Thermal cut-out
For your safety the appliance has a thermal
cut-out.
If the temperature inside the appliance
becomes too high, the appliance switches
off automatically:
1. Turn the function selector
1 to .
2. Check whether the air inlet or outlet is
obstructed and remove the cause.
If you cannot establish a cause and the
fault occurs repeatedly, have the
appliance repaired or else take it out of
use.
3. Wait for the appliance to cool down.
4. You can then continue to operate it
normally.
7.6 Safety switch
The appliance is protected against
accidental damage by a safety switch
11 .
The safety switch 11 is located on the bottom
of the appliance and switches the appliance
off immediately should it fall over:
• Return the appliance to an upright
position. The appliance will switch on
again automatically.
7.7 Frost protection setting
With this function, the appliance prevents
the room temperature falling below the frost
line:
1. Turn the temperature selector
2 to
the frost symbol.
2. Select the low or high heat setting on the
function selector 1 (see “7.2 Selecting
functions” on page 8).
7.8 Fan function
1. Select the fan function on the function
selector 1 .
2. Set the temperature selector 2 to ”MAX”.
7.9 Transporting the appliance
If you wish to transport the apliance, always
carry it by the lift-up carry handle
4 .
RP74339 KeramikHL LB4so2 Seite 9 Montag, 7. Mai 2012 2:19 14