Silvercrest SHLF 2000 A1 - Manual (Page 40)

38
4. Unpacking, setting up and inserting the battery
4.1 Setting up the appliance
Note! As the appliance and heating coils
are supplied with a thin film of grease, there
might be a small amount of smoke and
odour the first time the appliance is used.
This is not harmful and will stop after a short
while. Please ensure meanwhile that there is
sufficient ventilation.
1. Unpack the appliance from the
packaging.
2. Remove the transport packaging.
Note: There is a piece of corrugated
cardboard positioned between the
appliance and the base 9. This must also
be removed.
3. Check that the appliance shows no signs
of damage.
Warning! Ensure that there is suf-
ficient distance from the wall, fix-
tures and other appliances. The
distance must be at least 1.5 m to
exclude the risk of fire.
4. Select a location that complies with the
safety information (see “3. Safety infor-
mation” on page 35).
5. Select a location where the flow of hot
air is not directly aimed at people, ani-
mals or plants.
6. Plug the mains plug into a wall socket
that complies with the technical data.
Note:
The appliance consumes up to
10 amperes of current. If you have plug-
ged other power consumers into the
same circuit, check that the maximum
load for the installed fuse is not excee-
ded, as otherwise the fuse will trip.
4.2 Inserting the battery
If the appliance is new or the battery in the
remote control is flat, a new type CR2032
battery must be inserted.
1. Press the catch
towards the
middle and pull
out the battery
compartment.
2. Remove the old
battery if present.
Note:
Please observe the instructions for
disposal (see “8.2 Disposable/recharge-
able batteries” on page 42).
3. Insert a new battery.
Note: Ensure the correct polarity (+/–)
when inserting the battery. The correct
polarity is marked on the battery com-
partment.
4. Slide the battery compartment back in
again.
–
RP53439 HL mit FB LB5 Seite 38 Dienstag, 13. Juli 2010 2:18 14