Silvercrest SWD 100 C2 - Manual (Page 33)

33 GB/MT
If signs thereof are detected, the
heated blanket was used improp-
erly or will no longer heat up, it
must first be inspected by the man-
ufacturer before being switched
on again.
If the mains lead to the heated
blanket is damaged it must be
replaced by the manufacturer,
his customer service centre, or a
similarly qualified person to pre-
vent hazards.
With the heated blanket switched
on, never
– place objects on it (e.g. suit-
cases or clothes baskets),
– place a heating source such
as a hot-water bottle, heating
pad or similar items on it. The
heated blanket may otherwise
be damaged.
The electronic components inside
the control unit will heat up whilst
operating the heated blanket.
For this reason, never cover the
control unit or place it on the
heated blanket during operation.
This poses a risk of injuries and /
or damage to the heated blanket.
Always observe the information
on start-up, cleaning and care,
and storage.
If you have additional questions
on using our products, please
contact our Customer Service
Department.
Safety system
Note: The heated blanket features a safety system.
The electronic sensor technology prevents the heated
blanket from overheating across the entire surface
by automatically switching off in the event of a mal-
function.
If the safety system switches the heated blanket off
automatically as a result of a malfunction, the function
display
2 on the control unit 1 will no longer light
up, even when the heated blanket is switched on.
Please note that, for safety reasons, the heated
blanket must not be used after a fault and must
be returned to the service address indicated.
Special features
This heated blanket features a
super soft, hygienic fabric. The
textiles used in this heated blanket
satisfy the high human ecological
requirements of Öko-Tex Standard 100, as verified
by the German Hohenstein Research Institute.
Start­up
Note: When the heated blanket is used for the first
time, you may notice a smell of plastic; however, this
will disappear after a short time.
To use the heated blanket, first connect the con-
trol unit
1 with the heated blanket using the
plug-in connector 3 (see Fig. B).
Important safety instructions / Safety system / Special features / Start-up Important safety instructions