Cleaning – Silvercrest SSM 550 B1 User Manual
Page 39
- 37 -
Note
These recipes are provided subject to change. All
ingredients and preparation information are guiding
values. Expand these recipe suggestions based on
your personal experiences.
Note
For cases of lactose intolerance, we recommend
you use a lactose-free milk. Keep in mind, however,
that lactose-free milk is a little sweeter.
Cleaning
Caution!
Before starting to clean the liquidiser and its
components:
• Ensure that the motor is switched off and the
power plug removed from the socket.
Under no circumstance may the motor block
u
be submersed in water or other fluids.This
could result in you receiving a fatal electric
shock and the appliance could be damaged.
• Never open the housing of the appliance. This
brings with it the risk of receiving a fatal electric
shock.
• Never disassemble the cutters
r
and never re-
ach into the mixer jug
e
. The cutters
r
are extre-
mely sharp!
• Do not use solvents or abrasive cleaners on the
plastic surfaces, they could be damaged by them.
Cleaning the mixer
➩
So that you do not injure yourself on the cutters
r
, clean the mixer jug
e
only with a long
handled dishwasher brush.
➩
In a case of stubborn soiling, the mixer jug
e
can also be cleaned in a dishwasher. For this,
always take the mixing jug
e
apart, as
described later.
➩
Clean the lid
w
and the filling cap
q
in a dish-
washer or with the normal washing up.
If you clean the liquidiser directly after use, you can
often achieve a satisfactory and hygienic level of
cleaning with the following alternative:
➩
Fill the mixer jug
e
with water, close the lid
w
and place the mixer jug
e
on the motor
block
u
.
Insert the power plug into the wall socket and
activate the Ice Crush/Clean switch, causing the
cutters
r
to rotate in the water with maximum
revolutions.
Should this not dislodge the soiling, you can separate
the lower plastic part of the mixer jug
e
(with the cut-
ters
r
) from the the glass part:
➩
Remove the mixer jug
e
from the motor
block
u
.
➩
Turn the plastic element
of the mixer attach-
ment
e
anti-clockwise, such that it allows itself to
be released from the glass element
.
Attention!
Take care with the cutters
. They are very sharp.
Risk of injury!
IB_61457_SSM550B1_LB5 17.11.2010 11:48 Uhr Seite 37