Livarno Z31303A-BS Z31303B-BS - Manual (Page 25)

25 GB/MT
Safety / Bringing into use
required operating voltage for the
device (230 V~).
J Before connecting the device to the
mains you should always check the
device and the mains lead for any
damage. A damaged device repre-
sents the danger of death from
electric shock.
J Do not use the device if you find any
damage.
J Please consult a specialist electrician
if you discover any damage or prob-
lems with the device, or for the per-
formance of repairs to the device.
J Never open any of the electrical
equipment or insert any objects into
it. Such interventions represent the
danger of death from electric shock.
J It is essential that the device does
not come into contact with water or
other liquids.
J Protect the power supply cable 4
from sharp edges, mechanical strain
and hot surfaces.
J Never use the device in the immedi-
ate vicinity of a bathtub, shower or
swimming pool.
J Do not look directly into the light or
its reflection. Do not aim the light di-
rectly at people. This could produce
glare, leading to accidents.
J If direct or reflected light strikes your
eyes, close them and move your
head immediately out of the light.
J Operate the lamp only with supplied
mains adapter (LPS03-120-0100-
2W). Please note that any damage
caused through the use of a differ-
ent adapter is excluded from the
warranty.
J Never touch the mains adapter 6
with moist or wet hands.
J If the lamp is not to be used for an
extended period, e.g. while you
are away on holiday, then the mains
adapter 6 must be pulled out of
the mains socket.
J The bulb becomes hot during oper-
ation. Allow the lamp and bulb to
cool before you touch them.
J The LEDs cannot be replaced.
Q
Bringing into use
j Never direct the LED light beam on
to reflective surfaces or at people
or animals. Failure to observe this
advice may result in eye injury
and/ or loss of sight to people or
animals. Even a weak LED light
beam can cause eye damage.
j Attach the lamp in the desired posi-
tion by means of the clamp 2 .
77618A_B ES_IT_PT.indd 25 8/23/2012 5:22:03 PM