Livarno 3077-025L - Manual (Page 31)

32 GB
Preparation / Start-up / Changing the LED light bulb
Mounting garden light on the
wall / ceiling (Fig. A)
Note: you will need an electric drill for the instal-
lation.
CAUTION! DANGER OF INJURY! Please
refer to the operating instructions of your electric drill.
Note: The product can be used on all surfaces of-
ficially classified as being of normal flammability.
Mark the drill holes on the wall / ceiling using
the holes of the wall brackets 4 .
Now drill the fixing holes (Ø approx. 6 mm,
depth approx. 40 mm).
CAUTION! Make sure that you do not
damage any supply lines in the wall / ceiling.
Insert the dowels 5 into the drill holes. Use a
hammer if necessary to help.
Fasten the wall brackets to the surface with the
screws 2 .
Fasten the spotlights 1 onto the wall brackets
by screwing the union nuts 3 clockwise onto
the wall brackets.
Check for correct fitting.
Mounting garden light with
ground stake (Fig. C)
Fasten the spotlights 1 onto the ground stakes
10 by screwing the union nuts 3 clockwise
onto the ground stakes.
Inserting colour filter (Fig. B)
Open the spotlights 1 by turning the lamp
cover 9 anticlockwise.
Note: the LED light bulb 6 has already been
pre-installed.
Insert the desired colour filter 8 in the lamp
cover 9 and position the rough side of the
colour filter in the direction of the LED light bulb.
Close the spotlights by turning the lamp cover
9 clockwise.
Your light is now ready to use.
Directing the spotlights
CAUTION! DANGER OF BURN
INJURIES! Only change the posi-
tioning of the spotlights
1 when
the light is switched off and has cooled down
completely.
Note: Release the union nut 3 , since other-
wise the spotlights can not be moved.
Turn the individual spotlights in the desired
direction.
Tilt the individual spotlights to the desired angle.
Check afterwards that the spotlight are firmly
in place. Tighten up the union nut slightly if nec-
essary.
Start-up
Insert the mains plug 11 into the electrical
socket to switch on the light.
Pull the mains plug from the electrical socket to
switch off the light.
Changing the LED light
bulb (Fig. B)
Note: When changing the LED light bulbs, the
colour filter
8 can become lost, since this is only
inserted loosely.
Open the spotlights 1 by turning the lamp
cover 9 anticlockwise.
Use the enclosed suction cup 7 to change the
LED light bulbs. To do this, press the suction
cup onto the front face of the LED light bulb.
Remove the LED light bulb by turning this anti-
clockwise through a ¼ of a turn.
Insert the new LED light bulb carefully into the
holder using the suction cup and turn this clock-
wise by a ¼-of a turn.
Check for correct fitting.
Remove the suction cup by gently pulling on
the side nipple of the suction cup.
Close the spotlights by turning the lamp cover
9 clockwise.