Livarno Z31390 - Manual (Page 12)

12 GB/IE
Functioning
The solar cell installed in the article converts sun-
light into electrical energy and stores it in 1 NiMH
battery. Switches on the light as it begins to get
dark. The in-built light-emitting diodes are a very
long-life and energy-saving light source. The light
duration depends on the amount of sunlight, the
angle of light on the solar cell and the temperature
(the battery capacity is temperature-dependent).
A vertical angle of light at temperatures above
the freezing point is ideal. The battery does not
achieve maximum capacity until after several charge
and discharge cycles.
Preparing for use
Installing the light
Install the light in accordance with Figures A, D, E:
1. Rotate the solar cell housing
1 anticlockwise
out of the lamp shade 2 (see Fig. A).
2. Move the ON / OFF switch 5 into the ON
position to switch the light on.
86287_livx_Solarleuchte_content_LB3.indd 12 02.01.13 12:28