Livarno LED SPOTLIGHT - Manual (Page 21)

21 GB
Introduction / Safety
LED spotlight
Introduction
Congratulations on your new product.
You have selected a high quality prod-
uct. Please be sure to carefully read the
complete operating instructions. Fold out the page
with the illustrations. These instructions are part of
the product and contain important information on
setup and handling. Always follow all safety in-
structions. Before using this product for the first
time, verify that the voltage is correct and that all
parts are properly installed. Should you have any
questions or you are unsure about operating the
product, please contact the dealer or service centre.
Please keep these instructions in a safe place and
pass them on to third parties as applicable.
Intended use
This light is only suitable for indoor use in dry and
enclosed rooms. This light can be plugged into all
permanently installed sockets. This product is intended
for private household use only. This product is only
to be used as a wall light or reading light. Do not
use this light as a night light.
Scope of delivery
Check immediately after unpacking that the parts
are complete and that the product is in proper
condition.
1 LED spotlight, model 2635-014L/2635-014LS
1 Set of operating instructions
Parts description
1 Spotlight
2 Switch (continuous operation, or motion
detector in the case of darkness, or „off“)
Technical Data
Item no.: 2635-014L/2635-014LS
Operating voltage: 230–240 V∼, 50 Hz
Lamp:
21 SMD LEDs (SMD =
surface mounted device)
per spotlight (the LEDs are not
replaceable)
Rated power: 1 x 3 W
Protection class: 2635-014L: I/
2635-014LS: II/
Protection type: IP20
Safety
Safety notes
Damage due to failure to comply with these operat-
ing instructions will invalidate the guarantee! We
assume no liability for consequential damage! We
assume no liability for material damage or personal
injury due to improper handling or failure to comply
with the safety instructions!
Avoid the risk of fatal injury
from electric shock
Check the light for damage every time before
you use it. Never use the light if it shows any
signs of damage.
CAUTION! A damaged light means danger
of death from electric shock!
Check the light regularly and before every use
to see if there is any damage to the casing and
mains plug.
The light can not be repaired. If the light is
damaged, the product must be disposed of.
Ensure before use that the available mains
voltage is the same as the voltage required for
operating the lamp (230–240 V∼).
Strictly ensure that the light does not come into
contact with water or other liquids.
Never open any of the components of the elec-
trical equipment or insert any objects into the