Echo SRM-210i User Manual
Page 13
G
RASS
T
RIMMER
/B
RUSH
C
UTTER
O
PERATOR
'
S
M
ANUAL
13
NYLON
LINE
HEAD
INSTALLATION
1. Align hole in upper plate with notch in edge of gear housing and
insert head locking tool (C).
2. Be sure upper plate (A) remains on PTO shaft.
3. Place line head onto PTO shaft. Followed by large metal washer.
4. Thread L.H. nut on PTO shaft. Tighten securely.
5. Install new split pin.
6. Remove locking tool (C).
C
A
NYLON
LINE
INSTALLATION
1. Shut engine off. Lay unit on the ground with head assembly up.
2. Remove old nylon line through center recess of head.
3. Thread new lines through outside holes (D) in housing until ends
meet in center of recess.
NOTE
Insert cutting line ends to center of head recess to insure easy
removal of used lines.
FRONT
HANDLE
INSTALLATION
1.
Position front handle for comfortable operation and secure screws.
D
D
- GT-225 (32 pages)
- SRM-210 (32 pages)
- SRM-225 (44 pages)
- SRM-225 (24 pages)
- PAS ARTICULATING HEDGE CLIPPER ATTACHMENT PAS-2601 (20 pages)
- 670-200 (20 pages)
- PE-2000 Type 1/1E (30 pages)
- X7502026001 (36 pages)
- SB (56 pages)
- PAS RAPID LOADER 99944200610 (16 pages)
- 99944200610 (24 pages)
- SRM-261SB (16 pages)
- SRM-210SB (32 pages)
- PAS-230 (24 pages)
- PAS-230 (24 pages)
- PAS-230 (32 pages)
- PAS-260 (42 pages)
- PAS-261 (25 pages)
- 2410 - Type 2E (32 pages)
- GT-201 (28 pages)
- POWER PRUNER PPT-2400 (16 pages)
- HC-155 (32 pages)
- HC-155 (36 pages)
- Trimmer (20 pages)
- SRM - 265U (36 pages)
- HC-150 (28 pages)
- HC-235 (32 pages)
- HC-225 (32 pages)
- BLADE CONVERSION KIT 231 (8 pages)
- TC-2100 (28 pages)
- SRM-400 (20 pages)
- SRM - 260S (28 pages)
- 54 (4 pages)
- HCA-2400 (36 pages)
- CULTIVATOR PRO ATTACHMENT 99944200513 (16 pages)
- RM-5000 (68 pages)
- SRM-265T (44 pages)
- SHC-210 (28 pages)
- 2110 (37 pages)
- PE-3100 Type 1/1E (28 pages)
- SRM-265S (42 pages)
- SRM - 230U (32 pages)
- SRM-225I (36 pages)
- 99944200553 (16 pages)
- 99944200553 (24 pages)