Echo SRM-210i User Manual
Page 12
12
A
SSEMBLY
WARNING
DANGER
Use only ECHO approved attachments for these models. Serious injury may result from the use of non-approved
attachment combinations. Read and comply with all safety instructions listed in this manual and attachment manual.
ECHO, INC. will not be responsible for the failure of cutting devices, attachments or accessories which have not been
tested and approved by ECHO for use with these units.
B
A
PLASTIC
SHIELD
INSTALLATION
(For Nylon Line Operation)
NOTE
The plastic shield is for use with the Nylon Line Head only.
Install Metal Shield when using plastic or metal blades.
1. Remove plastic sleeve and upper plate (A) from PTO shaft.
2. Install the shield on the bottom of the bearing housing flange.
3. Place shield plate (B) on shield, align holes and install three (3)
5x16 mm screws.
4. Install upper plate (A) onto PTO shaft.
Tools Required: Screwdriver, Head Locking Tool (2), 17x14.5mm
Wrench, Needle Nose Pliers
Parts Required: Plastic Shield, Shield Plate, three (3) 5mm x 16mm
screws, Nylon Line Head, Two (2) Pre-cut Nylon Line
8 in. x .095 in., large washer, split pin, hex nut -
L.H. M10 x 1.25