Livarno Z31096 - Manual (Page 34)

34 GB
Installation
CAUTION! RISK OF INJURY!
Consult the drill manufacturer‘s operating
manual before you use your drill.
Installing the floor
light in soil or wooden
substrates
1. Choose a suitable location for the
floor light.
2. First excavate a hole with a depth
to match the height of the light in
the ground or drill a correspondingly
sized hole in a wooden substrate.
Note: Bear in mind that the decora-
tive collar
2 must be placed on top of
the substrate surface later (see Fig. G).
3. Switch the light on by pressing the
ON / OFF switch 9 .
Note: Please bear in mind that the
light will only switch itself on or off
under twilight conditions automati-
cally if the light is switched on.
4. Insert the light into the substrate.
Your light is now ready for operation.
Installing the floor light
in concrete substrates
Note: A quantity of mixed concrete is
required for this stage of the installation.
Follow the manufacturer’s instructions.
1. Choose a suitable location for the
floor light.
2. Drill a hole in the concrete substrate.
Note: Ensure that the depth of the
hole corresponds with the depth of the
floor insert
11 with concrete socket
including the floor light. Bear in mind
that the decorative collar
2 must be
placed on top of the substrate sur-
face later (see Fig. G).
3. Pour a little mixed concrete into the
predrilled hole.