Livarno Z31218A-BS Z31218B-BS Z31218C-BS - Manual (Page 11)

11 GB/MT
Disconnect the product from the mains supply if
it is not going to be used for some time (e.g.
holiday).
Use
Fitting bulb
Attention: Disconnect the power plug 5 prior to
fitting the bulb! Only bulbs with a maximum of 9 Watt
may be screwed into the socket. Using a higher
power output could cause damage to the lamp.
Note: Only bulbs with an E14 thread may be
used for this product.
Screw the bulb 2 lamp into the socket until a
flawless contact is enabled.
Switching the lamp on / off
Ensure that the operating voltage defined on
the lamp of 230 V∼, 50 Hz corresponds to
your mains voltage supply. Do not install the
light if this is not the case.
Insert the mains plug 5 into the mains socket.
Switch the lamp on and off using the switch 4
on the cord.
Aligning the lamp head
Align or direct the lamp head 7 by moving
the goose neck 6 . Never use force here.
Cleaning and Care
Use a dry, soft and fluff-free cloth for cleaning
and care.
Use a slightly moist cloth and a mild detergent
to remove stubborn dirt.
Note: Once the light bulb has been unscrewed
the lamp shade may also be unscrewed.
Disposal
The packaging is made entirely of recy-
clable materials which you can dispose
of at your local recycling facilities.
Contact your local refuse disposal authority for
more details of how to dispose of your worn-out
product.
Under no circumstances should the de-
vice / article and its bulbs be disposed
of with normal household rubbish.
Dispose of the device / article and illuminant at
registered waste disposal company or at your
communal waste disposal facility.
Observe the applicable regulations. In case of
doubt, please contact your waste disposal centre.
EMC