Livarno LED Desk Lamp - Manual (Page 22)

22 GB
Warranty and Service Safety / Start-up / Maintenance and Cleaning / Disposal
Always unplug from the mains before assem-
bling, disassembling, cleaning, or if the light
will not be used for an extended period.
Do not look directly into the light source
(light bulb, LED etc.).
Do not cover the lamp with objects. Excessive
heat can result in a fire.
The illuminant is not replaceable.
Avoid risk
of injury
RISK OF INJURY! Do not leave the lamp or
packaging material lying unattended. Plastic
film or bags, Styrofoam etc. can become
dangerous toys for children.
Safe working
Position the lamp so it is protected from
moisture and dirt.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Start-up
Assembling the light
Insert the light strip 1 into the rod 3 . Attach
the thread over the notch for the screw. Screw
the pin screws
5 into the light strip 1 until it
is flush with the housing.
Remove the lamp base 4 from the carton.
Insert the rod 3 onto the lamp base 4 .
Attach the threads over the notches for the screws.
Screw the pin screws 5 into the rod 3 until it
is flush with the housing.
Pull the cable out through the lamp base 4 .
Attach the non-slip coating to the underside of
the lamp base 4 .
Your lamp is now ready for use.
Operation
Set up the lamp onto an even, level surface.
Plug the plug adapter
6 for the power
cable 2 into the socket.
Activate the ON/OFF switch 2 on the light
strip 1 to switch the table lamp on or off.
Swivel the light strip 1 into the desired
direction.
Turn the light strip 1 in the desired direction.
Maintenance and Cleaning
Note: The device requires no maintenance.
The LED cannot be replaced.
Plug the plug adapter 6 from the socket.
CAUTION! RISK OF ELECTRIC SHOCK!
For electrical safety, never clean the light with
water or other liquids, or immerse it in water.
Only use a dry, lint-free cloth for cleaning.
Do not use solvents, benzene or similar sub-
stances. They could damage the light.
This light is not suitable for dimmer or electronic
switches.
This lamp is not suitable as a night light.
Disposal
The package and packaging materials
consist entirely of environmentally
friendly materials. They can be disposed
of at your local recycling facility.
The symbol of the wheelie bin with the
line through it means that, in the Euro-
pean Union, the product has to be
disposed of in a separate refuse collection. This
applies to the product and to all components bear-
ing this symbol. Do not dispose of products bearing
this symbol in your normal household waste, but
instead they must be taken for recycling to a collec-
tion site for electrical and electronic appliances.
Recycling helps to reduce the consumption of raw
materials and protects the environment.