Livarno Z30649A - Manual (Page 6)

6 GB
Q How to use
note: The light has a motion sensor that reacts to
temperature changes. The sensor works best at an
ambient temperature below 20 °C. A moving object
at a temperature close to the ambient temperature
is only detected with great difficulty.
note: The controls are at the front of the lamp,
above the motion sensor
8 (Fig. A).
The range of the motion sensor 8 is approx. 6 - 8
(+ / -1 - 2 m) if the lamp is installed at a height of
1.80 to 2.50 m (Fig. H). It has a roughly 100°
detection radius (Fig. I).
Q
regulating the
motion sensitivity
j Open the hinged lid 9 in order to be able to
operate the control to regulate the motion
sensitivity
6 .
j Turn the control to regulate the motion sensitivity
6 clockwise to increase the range of the motion
sensor 8 .
j Turn the control to regulate the motion sensi-
tivity 6 anti-clockwise to decrease the range
of the motion sensor 8 .
Q
regulating the sensitivity
of the light
j Open the hinged lid 9 in order to be able to
operate the control for light sensitivity 7 .
j Turn the control to regulate the light sensitivity 7
clockwise to increase the sensitivity of the light.
j Turn the control to regulate the light sensitivity 7
anti-clockwise to decrease the sensitivity of the
light.
note: When the lamp is switched on, the light
sensitivity sensor is switched off so that even despite
the brightness from the light movements can still be
detected.
Q regulating the duration
of the illumination
The amount of time the light stays on can be set to a
value between approx. 4 - 5 and 240 - 300 seconds.
j Open the hinged lid 9 in order to be able to
operate the control to regulate duration of light
5 .
j Turn the control to regulate the duration of the
illumination
5 clockwise to increase the dura-
tion of the illumination.
j Turn the control to regulate the duration of the
illumination
5 anti-clockwise to decrease the
duration of the illumination.
note: After the motion detector has switched the
light on, the light will stay on for the set period of time.
If during this period a new movement is detected,
the time the light stays on for will be extended by
the set period of time.
Q
replacing the illuminant
j Make sure that the lamp is dead, i.e. not live.
To do so, remove the fuse or move the switch
of the fuse in your sub-distribution to “
0”.
j The lamp can get very hot when in use. If nec-
essary, allow the lamp to cool down for about
15 minutes.
j Remove the lamp shade 1 and the sealing
ring 3 by screwing the lamp shade 1 out of
the lamp housing 4 .
j Remove the illuminant 2 from the base.
j Insert a new illuminant with a suitable base
and of an appropriate wattage (see section on
“Technical data”).
j Screw the lamp shade 1 back onto the lamp
body 4 .
j Switch the electrical power back on.
How to use / Cleaning and care