Mounting (see fig. a) – Livarno Z31228 User Manual

Page 11

Batteries must not be disposed

of in the normal domestic waste!

All end users are legally re-

quired to dispose of batteries
properly.

Mounting (see Fig. A)

Note: Clean the surface well
onto which you wish to mount the
product. The surface must be clean,
free from grease and dry. Other-
wise the stickiness of the double-
sided adhesive tape

might be

limited.
Note: Before use, check on a
hidden area of the surface, whether
the adhesive can cause damage.
Note: you will need a drill for
installation.

CAUTION! RISK OF

INJURY! Please refer to the
operating instructions of your drill.

CAUTION! Be sure not to

damage lines inside the wall.

Remove the protective film from

the adhesive on the back of
the light strips

and attach

the LED strip at the desired point.

Attach the LED driver

using the included double-
sided adhesive tape

the included screws

Connect the adaptor

the LED driver and the LED strip.
Note: Ensure when connect-
ing the LED driver

with the

LED strip that you align the
+GRB markings on the LED
driver with the +GRB marking
of LED strip.

Please ensure that the adaptor

is always accessible.

Insert the adaptor

into the

mains socket before you turn
on the product.

Connecting the 2 LED strips
(see Fig B):
Note: A maximum of two 5 m
LED strips can be connected with
the eight point plug

and oper-

ated with one LED driver and one
adaptor

. Otherwise there is

the risk of overloading the compo-
nents and fire.
Note: Ensure when connecting
the ends of the LED strip using the
eight point plug that you align the