Livarno Z32102B - Manual (Page 36)

36 GB/MT
Installing the light
For optimal results, place the product in a location where the solar cell unit 2 is
exposed to direct sunlight for as long as possible.
To adjust the angle of incidence, loosen the joint screw 5 to position the solar
cell unit correctly.
Then tighten the joint screw (see Fig. B).
Do not place the product under shrubs, trees, awnings, etc. This will reduce the
incidence of sunlight.
Position the product so the solar cell unit is not covered or shaded.
Make sure the solar cell unit is not impacted by other light sources, e.g. yard- or
street lighting, or the light will not switch on at twilight.
In low light the light will automatically switch on, and automatically switch off in
normal ambient light.
Note when using as accent lighting:
Push the assembled product far enough into the ground (grass, flower bed) to be
stable. Make sure it is firmly placed.
Do not use force during assembly or setup, e.g. hammer blows. This damages the
product.
63018_livx_B_LED-Solarspot_content_ES.indd 36 21.05.14 15:28