Livarno Z30894C - Manual (Page 3)

5 GB
Safety information / Before installation / Directing the lamps
CAUTION! Use 230 V∼ energy-saving
bulbs 10 with an E14 fitting and a maximum
power of 9 watt only.
CAUTION! RISK OF INJURY!
Any broken glass must be replaced
before any further use.
Danger to life by electric shock
Electrical installation must be performed by a
qualified electrician.
Every time before connecting the lamp to the
mains, check it and the mains lead for damage.
Dispose the light if you find it is damaged in
any way.
Before installation, remove the fuse for this circuit
or switch off the circuit breaker (0 setting) in the
fuse box.
Make sure before installing the light that the mains
voltage at the place of installation complies with
the operating voltage of the light (230 V∼) and
that the wire cross-section of the supply cable
is not less than 1 mm2. Do not install the light if
this is not the case.
Never let the lamp come into contact with
water or other liquids.
Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing
can lead to a serious danger to life from electric
shock.
Avoiding fire hazards
and risk of injury
CAUTION! RISK OF INJURY! Check the
lamps and light immediately on unpacking for
signs of damage. Do not install the light if you
discover any damage.
RISK OF ELECTRIC SHOCK!
RISK OF DAMAGE TO PROPERTY! RISK
OF INJURY! Ensure that you do not strike
electrical cables, gas or water pipes when you
are drilling into the ceiling. If necessary, check the
ceiling using a suitable detector before you drill.
0,5 m
FIRE HAZARD! Fit the light so that
it is at least 0.5 m away from the
material illuminated. Fire can result
from the development of too much heat.
CAUTION! RISK OF BURNS! Make sure
that the light is switched off and has cooled
down before you touch it. Lamps can become
very hot.
Correct procedure
Examine the ceiling before installation and
choose suitable installation fixings.
For ceiling installation we have supplied fixings
suitable for ordinary solid concrete or masonry
construction.
Use 230 V∼ energy-saving bulbs with an E14 fit-
ting and a maximum power of 9 watt only.
Fit the light in such a way to ensure it is protected
from damp and dirt.
Before installation
Before installation, please familiarise yourself
with the instructions and illustrations in this
operating manual and with the light itself.
Make sure before installation that there is no
voltage on the line you will be connecting the
light to. To do this, remove the fuse or switch off
the circuit breaker in the fuse box (0 position).
Check that there is no voltage using a voltage
tester.
CAUTION! RISK OF BURNS! Set the
height of the lamps before installation and bringing
them into use.
Directing the lamps
CAUTION! RISK OF BURNS! Set the height
of the lamps before installation and bringing them
into use.
66143_livx_Deckenleuchte_Z30894C_Content_LB4.indd 5 12.07.11 10:59